How the System Works
Restoring Nature's Beauty
By using this system your floor will acquire an even shine, be easier to maintain and as the finish develops the solid intact surface will be more resistant to stains and ingrained dirt.
A greater level of safety is created due to more foot to floor surface contact. The creation of this level of shine allows you to maintain the appearance you want without the use of chemicals.
Key Features
- Safer floor with increased slip resistance
- Superior finish created naturally
- Easy to implement and maintain
- Cost effective
- Recognised system - used by ASDA, TESCO, Somerfield and Co Op
It's very simple, quick and effective, both in cost and instant IMPACT.
Attach six polishing segments equally to the two pad drives of your scrubber drive. Lubricate with water, medium head pressure and a minimum of seven passes at a slightly reduced speed (compared to normal scrubbing speed).
A smoother floor surface is then produced increasing reflected light and shine. The floor also has increased slip resistance. Typically a slip resistance of 0.20 is measured before and 0.40 - 0.50 afterwards
Ongoing Maintenance
When to replace the diamond segments:
The polishing diamonds are only in the pods of the segment. If the pods are worn down (as shown below) the segments need replacing. Whenever replacing segments please replace the full set at the same time this is very important to achieve a consistent, even finish.
NOTE: Never mix sets or use part worn segments with new segments.
Disclaimer : Rokfloor Ltd accepts no responsibility for damage or injury caused by using the Diamond Pads and strongly recommends that all operators are fully trained in the Diamond Polishing process.